Diskette Drive (Optional) - HP Xw8200 - Workstation - 1 GB RAM Technical Reference Manual

If you are installing more than one optical drive, route the cable as in the following image.
NOTE The optical drive cable is routed under the system board.
Replacing Optical Drive Cable
The optical IDE cable is routed behind the system board.
1 Disconnect power from the system
workstation on its side with the system board facing up, remove all expansion boards and graphics
cards (page 84), remove the CPU heatsinks
system board, and remove the system board
2 Remove the plastic ties and tape from the IDE cable, then remove the IDE cable
3 Replace the cable and cable ties. Refer to the previous image for cable routing information.

Diskette Drive (Optional)

To remove a diskette drive:
1 Disconnect power from the system
front bezel (page 71).
(page 66), remove the access panel
(page 96), disconnect the optical IDE cable from the
(page 101).
(page 66), remove the access panel
REMOVAL AND REPLACEMENT OF COMPONENTS 89
(page 71), lay the
(page 71), and remove the