Selecting Constant DHW Heating
Setting up an individual time program
DHW time prog.
1-7
DHW time prog.
Mo
(continued)
The following explains the setting up of a time program using DHW heating "uw"
as an example. For the DHW recirculation pump time program, proceed as described
above, after you have selected "Recirc. pump time program".
Press the following keys:
1. uw for "DHW time program.".
Note:
If you want to terminate the time
programming early, press "uw"
again and confirm with
2. ⊕/⊝ to select "DHW time
program.", or "Recirc. pump
time program.".
3.
to confirm.
4. ⊕/⊝ for "Individual?", if Individual?"
is not yet displayed.
5.
to confirm.
6. ⊕/⊝ until "1-7" is displayed, if you
want to set up the same time
phases for every day.
Or..
7. ⊕/⊝ until "Mo", "Tu" etc. is
displayed, if you want to set
different time phases for the
displayed day.
8.
to confirm; "DHW timer 1" will
then be displayed.
to confirm; "DHW timer 1 ON"
9.
will then be displayed.
10. ⊕/⊝for DHW phase starting point.
11.
to confirm; "DHW cycle 1 Off"
will be displayed.
12. ⊕/⊝for DHW phase end point.
13.
to confirm; "DHW cycle 2 On"
will then be displayed.
14. Proceed for setting the start and
end of DHW phases 2 to 4 as
described in steps 9 to 11.
Selecting DHW Heating
.
Note:
If different time phases are set for
individual days and you want to
return to identical time phases for
every day, press
displayed.
All time phases are returned to their
original delivered condition.
Note:
Press ⊕ if you want to skip a time
phase.
when "1-7" is
27