Adjusting the Room Temperature
Setting a Permanent Room Temperature
Selecting normal room temperature
+
18
Observe the following points if your
heating circuit should provide central
heating.
H "Heating & DHW" "rw" must be
illuminated, otherwise press "rw".
If "Select heating circuit" is displayed
and "1r" flashes:,
- Select the heating circuit with ⊕ / ⊝,
to which the central heating should
apply.
- Confirm twice with
.
- If "rw" does not illuminate, press
"rw" again.
Select the required temperature for the
"Normal room temp." with selector dial
"ts".
Normal room temp.
68
ºF
s
If "Select htg. circuit" is displayed and
"1r" flashes:
H Select the heating circuit with ⊕ / ⊝,
to which the central heating should
apply.
H Confirm twice with
.
H Set the required temperature for
"Normal room temp." with selector dial
"ts".
H You can select the normal room
temperature "ts" (for day) and the
reduced room temperature (for night)
with "tm".
H The timing of when your heating
circuit operates to provide central
heating with normal or reduced room
temperature depends on the settings
of the time program (see page 20).
- If no time phases are selected, central
heating will be enabled for the whole
day at reduced room temperature.
- If one or more time phases are
selected, central heating will be
enabled for those times with normal
room temperature.
You can scan the time program, (see
page 33).
For changing the time program, (see
page 20).