Setting The Time Program For Central Heating - Viessmann B2HAH13 Operating Instructions Manual

Heating

Setting the Time Program for Central Heating

18
Vitodens 200-W B2HA/B2HB, 222-F B2TA/B2TB Operating
H The time program for central heating is made up of time
phases. Constant 24 h for every day of the week is set
at the factory.
H You can set the time program individually, to be the
same for every day of the week or different: You can
select up to 4 time phases per day for standard heating
mode. Set the start and end points for each time phase.
Between these time phases, the rooms are heated with
the reduced room temperature (see chapter "Setting the
room temperature for reduced heating mode").
H When setting, bear in mind that your heating system
requires some time to heat the rooms to the required
temperature.
H In the extended menu, you can scan the current time
program under "Information" (see chapter "Scanning
information", "Heating circuit ..." group).
Extended menu:
1.
2. "Heating"
3. Select the heating circuit if necessary.
4. "Heating time program"
5. Select part of the week or a day.
6. Select the time phase !, ?, § or $.
7. Set the start and end points for the relevant time
phase.
8. Press to exit the menu.
Note: If you want to terminate a time phase setting
process prematurely, keep pressing
required display appears.
Example shown:
- Time program for Monday to Friday ("Mo-Fr")
- Time phase !: From 05:00 to 08:30 h
- Time phase ?: From 16:30 to 23:00 h
Example:
You want to set the same time program for every day
except Monday:
Select the period "Monday–Sunday" and set the time
program.
Then select "Monday" and set the time program for this.
Deleting a time phase
Set the time for the end point to the same time that was
set for the start point. The display shows the selected
time phase
until the