Table of Contents
Advertisement
Quick Start Guide
Electrostatic discharge may cause damage to component. Components can be damaged invisibly by
electrostatic discharge during transportation, storage and use.
The following measure can reduce the damage of electrostatic discharge,
• Testing in antistatic area as far as possible；
• Before connecting the power cable to the instrument, inner and outer conductors of the instrument
should be briefly grounded to discharge static electricity;
• Ensure all the instruments are properly grounded to prevent the accumulation of static.
Preparation Work
1. Connecting the power cable and insert the power plug into protective grounding outlet; use the tilt
adjustment bracket as needed for your viewing angle.
2. Press the switch on the rear panel
3. Press the switch on the front panel
powered on.
It takes about 30 seconds to initialize the boot, and then the spectrum analyzer enters the system default
menu mode. In order to make this spectrum analyzer perform better, it is recommended that warm up
the spectrum analyzer for 45 minutes after power on.
Usage Tip
Use External Reference Signal
If user want to use an external signal source 10 MHz as reference, please connect signal source to the 10
MHz In port on the rear panel. The measuring bar on the top of the screen will indicate Reference Frequency:
External.
Activate the Option
If user want to activate the option, user need to input secret key of the option. Please contact UNI-T office
to purchase it.
Refer to the following steps to activate the option you have purchased.
1. Save the secret key into USB and then insert it to spectrum analyzer;
2. Press [System] key > System Information > add token；
3. Select purchased secret key and then press [ENTER] to confirm.
Touch Operation
Instruments.uni-trend.com
Figure 2-1 Tilt adjustment
, the spectrum analyzer will enter standby mode.
, indicator lights up green, and then the spectrum analyzer is
UTS1000B/T Series
15 / 18
Advertisement
Table of Contents
