Chapter 6 Communication; Communication Command - UNI-T UTE9800+ Series User Manual

Smart digital power meter

Hide thumbs

Table Of Contents

Table of Contents

User's Manual

triggered;

2. Only set the lower limit, if the measured value is less than the upper limit D----alarm will be triggered;

3. Set the upper and lower limit, if the measured value is greater than the upper limit U or the measured

value is less than the upper limit D----alarm will be triggered;

4. If set he upper limit is less than the lower limit, then the current parameter is valid, alarm will not be

activated.

Alarm Method

UTE9806+ supports audible and visual alarm. When the measurement value of any parameter exceeds

the set range, the instrument will trigger an alarm and show the NG identifier on the display screen.

OUT0

0: input alarm switch

ON: If the measured data is 0, alarm will be activated.

OFF: If the measured data is 0, alarm will not be activated.

BEEP

The number of audible alarms, with a frequency of about three alarms per second.

1~9999: Beep will sound when the alarm is triggered.

0: Beep does not sound when the alarm is triggered.

DELAY

The number of alarm delay, it is related to the interval between data updates.

It starts to count when a measured value is not within the set range at some point. The alarm will be

triggered only when the measured value exceeds the set range for several consecutive times.

Range of delay times: 0000～9999

LEDF

Blinking switch of the instrument

ON: Blinking function is enabled.

OFF: Blinking function is disabled.

When the measured data is greater than the upper limit, measured data and"￣￣￣￣"will alternate

blinking.

When the measured data is less than the lower limit, measured data and" ＿＿＿＿ "will alternate

blinking.