Directed Electronics READY REMOTE 24927 Owner's Installation Manual page 78

Safety shut down inputs:
While the vehicle is running during remote start operation, the
system will monitor the vehicle and will automatically shut down
the engine if the system receives any of the following signals:
➤
The brake pedal is pressed.
➤
The hood is opened.
➤
The programmed run time has elapsed.
➤
The alarm is triggered.
➤
Low battery voltage.
➤
High or low tachometer signal.
Quick Stop Mode
The Quick Stop feature allows the vehicle to remain running after
the key has been removed from the ignition. This feature is useful
for occasions when you wish to exit and lock the vehicle for short
periods of time, but would like to leave the motor running and the
climate controls on.
To activate Quick Stop:
➤
With the ignition On and the engine running, do one of
the following:
■ Press and release on the transmitter
twice.
■ Press and release the Momentary Switch 4 times
quickly
■
Pulse the activation input wire twice
➤
The Horn/Siren will chirp once and the lights will begin
© 2007 Directed Electronics
button
79