Testing The System - Directed Electronics READY REMOTE 24927 Owner's Installation Manual

Testing the System

Once steps 1-7 have been completed, the operation of the system
can be tested.
Ensure that the two 30-amp fuses are in the relay harness PINK
wire fuse holders. Make sure that the vehicle is in park with the
emergency brake on and the hood closed. Press on the remote
to initiate the remote start function. The parking lights should
flash to confirm the remote start command has been received. The
accessories and ignition should turn on followed by the starter
cranking and the vehicle engine running (this may take a moment
to initiate). Pressing on the remote will shut the engine off.
(See Programming System settings section for one-press remote
start operation)
This completes the testing. If all functions do not work correctly,
check your wiring against the manual and verify all connections.
If you still experience problems, contact Directed Technical
Support at 1-800-477-1382.
© 2007 Directed Electronics
68