Accessory And Starter Wires - Directed Electronics READY REMOTE 24921 Installation Manual

Accessory and starter Wires

H2/2 PURPLE
H2/3 ORANGE
The starter and accessory wires will be located in the same harness as the ignition and constant power.
To find the accessory wire, leave the multimeter's black lead connected to ground. Take the red lead and
probe the wire suspected to be the accessory wire. With the key off, your multimeter should read 0 volts.
Turn the key to the on position The multimeter should read 12 volts. Now turn the key to the crank position.
If you have the correct accessory wire, the multimeter will read 0 volts while the starter is cranking, and 12
volts once the key returns to the on position. If the wire tests correctly, strip some insulation off and solder the
ORANGE heavy gauge wire and wrap it with electrical tape.
If your vehicle requires more than one accessory and the PINK/WHITE wire is not being used for 2nd ignition,
you can program the PINK/WHITE to be a 2nd accessory output. This setting may be found in the Feature
Menu, Feature # 6.
If the PINK/WHITE wire is being used for Ignition 2, an additional relay (not provided) is required for a 2nd
accessory. Refer to the diagram below.
© 2010 Directed Electronics. All rights reserved.
OUTPUT TO STARTER CIRCUIT, 30A (+)
OUTPUT TO ACCESSORY CIRCUIT, 30A (+)
+12 VDC CONSTANT (FUSED 20A)
+12 VDC CONSTANT (FUSED 20A)
ORANGE (+) 30A OUTPUT TO
ACCESSORY CIRCUIT
1st ACCESSORY RELAY
(NOT PROVIDED)
87
GROUND
86 85
87A
30
TO ACCESSORY
2 nd ACCESSORY RELAY
(NOT PROVIDED)
87
GROUND
86 87A 85
30
TO 2 nd ACCESSORY
11