Installation Instructions; Before You Start - Directed Electronics AutoCommand 25522 Installation Manual

“add-on” remote control car starter
Table of Contents

Advertisement

!! WARNING !!
On cars with airbags, you may notice bright yellow tubes or harnesses under-
neath the steering column area. DO NOT tamper with these wires in any way,
so as to prevent personal injury and/or damage to the air bag system.
Battery gases are explosive. Do not smoke while working near the car's bat-
tery.
!!CAUTION!!
When working the wires through the car's firewall, be sure to protect them
from sharp metal edges and from hot surfaces on the engine.
Note:
Some installers connect a battery charger to the vehicle's battery dur-
ing installation. This is fine, but it must be removed before running the vehicle
under AutoCommand
control.
®

INSTALLATION INSTRUCTIONS

1. Before You Start

Take the time to read through the whole installation manual.
Wire Harnesses: Before installation, always check that your wire
harness matches the list/drawing on page 4 of the manual.
IMPORTANT:
After having read the entire manual, start the
installation by putting the yellow WARNING STICKER in the engine com-
partment. Choose a surface that is clean and readily visible when the hood is
open.
5
© 2005 Directed Electronics, Inc.

Advertisement

Table of Contents
loading

Table of Contents