Playback Procedure - Sansui HDLCDVD325 Owner's Manual

NOTES:
• If a non-compatible disc is loaded,
"Incorrect Disc", "Region Code Error"
or "Parental Error" will appear on the TV
screen according to the type of loaded
disc. If these appear, check your disc
again (see pages 7 and 54).
• Some discs may take a minute or so
to start playback.
• A "Prohibition" symbol " " may appear
at the upper left of the screen. This
symbol means either the feature you
tried is not available on the disc, or the
unit cannot access the feature at this
time. This does not indicate a problem
with the unit.
• When you set a single-faced disc label
downwards (i.e. the wrong way up)
"Reading" will appear on the display
and then "Incorrect Disc" will be
displayed.
• Some playback operations of DVDs
may be intentionally fixed by software
producers. Since this unit plays DVDs
according to the disc content recorded,
some playback features may not be
available. Also refer to the instructions
supplied with the DVDs.

Playback procedure

1
Press TV/DVD to select DVD mode.
2
Place the disc in the disc
slot with the label side
facing forward. (If the
disc has a label.) Hold
the disc without touching
either of its surfaces,
align it with the guides, and place it in position.
3
On the screen, "No Disc"
changes to "Reading" and
then playback will
commence.
• A menu screen may
appear on the TV screen,
if the disc has a menu
feature. In this case,
press , , ,
ENTER to operate a
menu feature.
4
Press STOP to end playback.
• The unit memorizes the stopped point, depending on
the disc. " " appears on the screen. Press PLAY to
resume playback (from the scene point).
• If you press STOP again ("
or unload the disc, the unit will clear the stopped point.
5
Press 5 5 5 5 5 (EJECT).
Remove the disc and then press POWER.
The unit turns off.
When you eject the disc, you may hear mechanism noise,
but it is not malfunction.
No Disc
or
Reading
" appears on the screen)
39