Canon LBP-2000 Service Manual page 22

CHAPTER 1
11) Turn on the power switch, and check to make sure that the LNK lamp (green) of the print
server is ON.
• In the case of 10Base-T, check to make sure that the LNK lamp is ON.
• In the case of 100Base-T, check to make sure that the LNK lamp and the 100 lamp are ON.
12) Turn on the power switch.
13) Thread the LAN cable through the groove in the expansion board slot cover, and secure the
expansion board slot cover with a screw.
5 . Checking the operation
1) Put paper in the cassette.
2) Connect the grounding wire to the Printer.
3) Connect the power cord to the Printer and the power outlet, and turn on the power switch. Be
sure that the power cord is one designed for the Printer.
4) When the Printer is in standby state, press the Go key so that it enters off-line state.
5) Press the Menu key once, and press the Item key until the status indicator panel indicates
'TEST PRINT'.
6) Press the Enter key to execute 'TEST PRINT'. Check the test print for faulty images. If an
option has been installed, check to make sure that its presence is indicated.
7) Clean up the area around the Printer, and set the Printer ready for use.
1 - 16
ERR lamp
LNK lamp
100 lamp
Figure 1-5-11
Figure 1-5-12