Canon LBP-2000 Service Manual page 113

2) Connect the connector [5] to the control
panel, and mount the control panel [6]
to the upper cover [7].
[6]
[7]
Figure 3-1-8
3) Mount the extension slot cover.
3 . Removing the front cover
Caution: If you must work for 5 min or
more, be sure to slide out the car-
tridge and keep it in a protective
b a g .
1) Open the multifeeder tray.
2) Shift the open/close levers [1] found on
both side of the front cover to the front,
and slide out the front cover [2].
[1]
[2]
Figure 3-1-9
3) Lift the front cover [3] slightly to detach.
[5]
4 . Remove the left cover
Caution: If a hard disk (option) is installed,
1) Remove the upper cover.
2) Slide out the front cover slightly.
3) Remove the screw [1], and detach the left
[3]
Figure 3-1-10
be sure to remove it in advance.
(See II-B-6 'Removing the Hard
Disk (option).'
cover [2].
[1]
Figure 3-1-11
CHAPTER 3
[2]
3 - 3