Canon LBP-2000 Service Manual page 218

APPENDIX
M e s s a g e
FLASH ERROR The optional Flash ROM
error occurred.
WRITING DISK Unable to write to the printer
ERROR hard disk.
READING DISK Unable to read the printer
ERROR hard disk.
MEM ALLOC Not enough memory to
ERROR process the data and print
the page.
PARALLEL INTER- A parallel port error oc-
FACE ERROR c u r r e d .
U S B An USB port error occurred.
INTERFACE ERROR
ETHERNET An Extended Interface error
OPTION ERROR o c c u r r e d .
JOB STORING The receiving print job will
R E J E C T E D s t o p .
A - 14
M e a n i n g
Replace the optional Flash ROM.
Measure 1: Make sure that the printer hard
disk is installed correctly.
Measure 2: Turn off the printer, and the turn it
on again.
Measure 3: Format the printer hard disk.
Measure 1: Make sure that the printer hard
disk is installed correctly.
Measure 2: Turn off the printer, and the turn it
on again.
Measure 3: Format the printer hard disk.
If AUTOCONT is ON (CONFIG MENU), the
printer will be put back online after 10 seconds.
If AUTOCONT is OFF, press the Go key to put
the printer back online.
Check the printed page to ensure that the print
job is complete.
Perform the troubleshooting procedure de-
scribed in Section VI of Chapter 4.
The amount of stored job logs will exceed the
maximum limit.
Delete unnecessary job logs from the printer
hard disk.
Action