Canon LBP-2000 Service Manual page 219

e . The following messages are displayed on the SERVICE mode.
M e s s a g e
NVRAM OK All NVRAMs work correctly.
NVRAMx ERROR An error occurred in the
NVRAMx.
WRITING NVRAMx A writing error occurred in
ERROR the NVRAMx.
CHECK NVRAM Incorrect information has
been found in the NVRAM.
+REALLY/-IGNORE Duplicate page counter
x -> y information from the
NVRAMx to the NVRAMy?
+ FORMAT DISK Format the printer hard
- IGNORE DISK d i s k ?
+ REALLY FORMAT The operator is being asked
- IGNORE DISK to verify the disk formatting
is really wanted. This is in
response to the foregoing
m e s s a g e .
START DISK TEST Start the hard disk test?
ENTER ENDS TEST Stop the hard disk test?
FORMATTING... The printer hard disk is
being formatted.
DSK FMT RESTART The printer hard disk has
been
+ FORMAT FLASH Format the optional Flash
- IGNORE FLASH ROM?
+ REALLY FORMAT Continue formatting the
- IGNORE FLASH optional Flash ROM?
FLASH FORMAT The optional Flash ROM has
RESTART been formatted. The printer
will restart.
FLASH The optional Flash ROM is
FORMATTING... being formatted.
+ REALLY CLEAR Clear the device password?
- IGNORE CLEAR
DONE The operation of clearing a
password or error flag of
engine NVRAM has done
successfully.
FAILED The operation of clearing a
password has failed.
M e a n i n g
formatted.
Action
Reinstall or replace the NVRAM.
Replace the NVRAM.
Replace the NVRAM.
Select + (press the Value key) to continue
duplication, or select - (press the Shift and
Value keys) to cancel the operation.
Select + (press the Value key) to continue, or
select - (press the Shift and Value keys) to
c a n c e l .
Press + to verify that the disk is to be formatted
or press - to skip formatting the disk. This
message will not display for new/unformatted
disk (e.g. The disk is to be formatted for the 1st
time)
Press the Enter/Cancel key to begin testing the
printer hard disk.
To stop the disk test, press the Enter/Cancel
key again. Once the test is stopped, you will be
asked to FORMAT DISK after printer restarts.
Press the Enter/Cancel key to end testing the
printer hard disk.
The printer will automatically restart to format
the hard disk.
Wait a moment for the operation to complete.
Press the Enter key to restart the printer.
Select + (press the Value key) to continue, or
select - (press the Shift and Value) to cancel.
Select + (press the Value key) to begin format-
ting the Flash ROM, or select - (press the Shift
and Value keys) to cancel the operation.
Wait a moment for the operation to complete.
Wait a moment for the operation to complete.
Select + (press the Value key) to clear the device
password, or select - (press the Shift and Value
keys) to cancel the operation.
APPENDIX
A - 15