Charging Assemblies; Installing The Ap Kit And The Charging Assemblies - Canon NP6260 Service Manual

CHAPTER 9 INSTALLATION
D. Installing the AP Kit and the Charging Assemblies
Step
1 While pushing the rear (fixing/
feeding assembly inside) of the
releasing lever locking shaft, shift up
the releasing lever. Remove the two
screws, and remove the feeding
assembly front cover.
2 Remove the screw, and remove the
metal fixing; then, disconnect the
connector. Holding the front and the
rear of the
charging
assembly to the front, and then pull it
to the upper left to remove.
Using alcohol, clean the transfer/
separation charging assembly.
Install the
charging assembly, connect the
connector.
Install the metal fixing.
Caution:
Be sure to keep the transfer/
separation charging assembly
in contact with the transfer
guide, and take care not to
damage the gut wire.
Further, be sure that the
charging assembly is fully dry.
9-10
COPYRIGHT © 1997 CANON INC.
Work
transfer/separation
assembly, pull
transfer/separation
CANON NP6560/NP6360/NP6260 REV. 0 NOV. 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
Releasing
lever
the
Metal
Screw
fixing
Remarks
Releasing lever
locking shaft
(rear)
Screw
Feeding assembly
front cover
Connector