K. Duplexing Drive (1) Assembly
1. Construction
2. Removing
1) Open the front door, and slide out
the holding tray assembly about 10
cm from the copier.
2) Remove the rear cover.
3) Remove the DC controller PCB.
4) Remove the spring
sioner, and detach the timing belt.
5) Remove the four mounting screws
, and remove the duplexing drive
(1) assembly
COPYRIGHT © 1997 CANON INC.
of the ten-
.
CANON NP6560/NP6360/NP6260 REV. 0 NOV. 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 7 EXTERNALS/AUXILIARY MECHANISMS
Figure 7-457
Figure 7-458
7-39