Canon NP6260 Service Manual page 421

3) Remove the compartment from the
deck. (See p. 8-28.)
4) Disconnect the two connectors
and remove the five screws
remove the deck lifter motor unit
5. Removing the Lifter Cable (deck
front)
1) Open the compartment of the deck;
remove all copy paper, if any.
2) Remove the screw, and remove the
trailing edge guide plate from inside
the compartment.
3) Push the sensor lever
paper supply sensor inside the
compartment with a finger to lower
the lifter until the holes (left-right) in
the compartment side plate and the
holes (left/right) in the lifter match;
then, insert two screwdrivers (to
position the lifter).
COPYRIGHT © 1997 CANON INC.
,
; then,
.
of the
CANON NP6560/NP6360/NP6260 REV. 0 NOV. 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 8 PAPER DECK-A1
Figure 8-405
Figure 8-406
8-35