Brady BBP11-34L User Manual page 26

After initialization, printer configuration will be restored to defaults as shown in the table.
Speed
Density
Label Width
Label Height
Sensor Type
Gap Setting
Print Direction
Reference Point
Offset
Tear Mode
Peel off Mode
Cutter Mode
Serial Port Settings
Code Page
Country Code
Clear Flash Memory
IP Address
Set Black Mark Sensor as Media Sensor and Calibrate the Black Mark Sensor
To set Black Mark Sensor:
1. Turn off the power switch.
2. Hold the Feed button down, then turn the power switch ON.
3. Release the ONbutton when LED turns green/amber after 5 green blinks. (Any
green/amber will do during the 5 blinks).
The LED color changes as follows:
•
Set Gap Sensor as Media Sensor and Calibrate the Gap Sensor
To set Gap Sensor:
1. Turn off the power switch.
2. Hold the Feed button down, then turn the power switch ON.
3. Release the button when LED turns red/amber after 5 green/amber blinks (any time
during the 5 blinks).
The LED color changes as follows:
•
22
Parameter
127 mm/sec (5 ips) (203DPI)
76 mm/sec (3 ips) (300DPI)
8
4" (101.5 mm)
4" (101.5 mm)
Gap sensor
0.12" (3.0 mm)
0
0,0 (upper left corner)
0
On
Off
Off
9600 bps, none parity, 8 data bits, 1 stop bit
850
001
No
DHCP
Amber Red (5 blinks)
Green/Amber (5 blinks)
Amber Red (5 blinks)
Green/Amber (5 blinks)
Default setting
Amber (5 blinks) Green (5 blinks)
Red/Amber (5 blinks)
Amber (5 blinks) Green (5 blinks)
Red/Amber (5 blinks)
Solid Green
Solid Green
BPP11 User Manual