Web Gui.; Cisco Small Business 200 Series Smart Switch Administration Guide - Cisco SD208T-NA Administration Manual

Configuring IP Information
Management and IP Interfaces

Cisco Small Business 200 Series Smart Switch Administration Guide

• Management VLAN—Select the Management VLAN used to access the
switch through telnet or the Web GUI. VLAN1 is the default Management
VLAN.
• IP Address Type—Select one of the following options:
Dynamic
- —Discover the IP address using DHCP from the management
VLAN.
Static
- —Manually define a static IP address.
DHCP Option 12 (Host Name option) is supported when the device is
NOTE
an DHCP client. If DHCP Option 12 is received from a DHCP server, it is saved
as the server's host name. DHCP option 12 will not be requested by the
switch. The DHCP server must be configured to send option 12 regardless
of what is requested in order to make use of this feature.
If a static IP address is used, configure the following fields.
• IP Address—Enter the IP address, and configure one of the following fields:
- Network Mask—Select and enter the IP address mask.
- Prefix Length—Select and enter the length of the IPv4 address prefix.
• Administrative Default Gateway—Select User Defined and enter the
default gateway IP address, or select None to remove the selected default
gateway IP address from the interface.
• Operational Default Gateway—Displays the current default gateway
status.
If the switch is not configured with a default gateway, it cannot
NOTE
communicate with other devices that are not in the same IP subnet.
If a dynamic IP address is retrieved from the DHCP server, select those of the
following fields that are enabled:
• Renew IP Address Now—The switch dynamic IP address can be renewed
any time after it is assigned by a DHCP server. Note that depending on your
DHCP server configuration, the switch might receive a new IP address after
the renewal that requires setting the web-based switch configuration utility
to the new IP address.
• Auto Configuration via DHCP—Displays status of Auto Configuration
feature. You can configure this from
DHCP Auto Configuration
Administration
.
16
File Management
> >
210