Table of Contents
Advertisement
Configuring Multicast Forwarding
Querying IGMP/MLD IP Multicast Group
Querying IGMP/MLD IP Multicast Group
STEP 1
STEP 2
STEP 3
STEP 4
Cisco Small Business 200 Series Smart Switch Administration Guide
IGMP/MLD IP Multicast Group
The
learned from IGMP/MLD messages.
There might be a difference between information on this page and, for example,
information displayed in the
is in MAC-based groups and a port that requested to join the following Multicast
groups 224. 1 . 1 . 1 and 225. 1 . 1 . 1 , both are mapped to the same MAC Multicast
address 01:00:5e:01:01:01. In this case, there is a single entry in the
page, but two entries on this page.
To query for a IP Multicast group:
Click Multicast > IGMP/MLD IP Multicast Group. The IGMP/MLD IP Multicast
Group page opens.
Set the type of snooping group for which to search: IGMP or MLD.
Enter some or all of following query filter criteria:
•
Group Address equals to—Defines the Multicast group MAC address or IP
address to query.
•
Source Address equals to—Defines the sender address to query.
•
VLAN ID equals to—Defines the VLAN ID to query.
Click Go. The following fields are displayed for each Multicast group:
•
VLAN—The VLAN ID.
•
Group Address—The Multicast group MAC address or IP address.
•
Source Address—The sender address for all of the specified group ports.
•
Included Ports—The list of destination ports for the Multicast stream.
•
Excluded Ports—The list of ports not included in the group.
•
Compatibility Mode—The oldest IGMP/MLD version of registration from the
hosts the switch receives on the IP group address.
page displays the IPv4 and IPv6 group address
MAC Group Address
page
.
Assuming that the system
MAC Multicast
15
204
Hide quick links:
Advertisement
Table of Contents
