Cisco SD208T-NA Administration Manual page 233

Configuring Security
Defining Management Access Method
Cisco Small Business 200 Series Smart Switch Administration Guide
• Rule Priority—Enter the rule priority. When the packet is matched to a rule,
user groups are either granted or denied access to the switch. The rule
priority is essential to matching packets to rules, as packets are matched on
a first-match basis. One is the highest priority.
• Management Method—Select the management method for which the rule
is defined. The options are:
- All—Assigns all management methods to the rule.
- HTTP— Users requesting access to the switch that meets the HTTP
access profile criteria, are permitted or denied.
- Secure HTTP (HTTPS)—Users requesting access to the switch that
meets the HTTPS access profile criteria, are permitted or denied.
• Action—Select the action attached to the rule. The options are:
- Permit—Permits access to the switch if the user matches the settings in
the profile.
- Deny—Denies access to the switch if the user matches the settings in the
profile.
• Applies to Interface—Select the interface attached to the rule. The options
are:
- All—Applies to all ports, VLANs, and LAGs.
- User Defined—Applies to selected interface.
• Interface—Enter the interface number if User Defined was selected.
• Applies to Source IP Address—Select the type of source IP address to
which the access profile applies. The Source IP Address field is valid for a
subnetwork. Select one of the following values:
- All—Applies to all types of IP addresses.
- User Defined—Applies to only those types of IP addresses defined in
the fields.
• IP Version—Select the supported IP version of the source address, IPv6 or
IPv4.
• IP Address—Enter the source IP address.
• Mask—Select the format for the subnet mask for the source IP address, and
enter a value in one of the fields:
17
234