Ieee1394B Driver For Windows; Before Installation; Installation Of The Ieee1394B Driver - Panasonic AJ-PCD20E Operating Instructions Manual

IEEE1394b Driver for Windows

This driver is for the IEEE1394b interface for the
P2 card on this unit.

1) Before installation

System requirements for the IEEE1394b driver
are as follows.
OS: Windows XP Professional SP2 or higher
RAM: 512 MB or more (1 GB or more is
recommended)
®
CPU: Pentium 4
recommended
<Note>
The IEEE1394b connection in Windows 2000 is
not supported.
Before installing the IEEE1394b driver, install
the update program provided by Microsoft in
accordance with the following procedures. If the
updates are not installed, a sufficient transfer
rate may not be obtained.
1
Open the Web browser and navigate to the
Microsoft website.
2
Enter "KB885222" in the search column on
the website, and then press the search
button.
3
Click the link for "Performance of 1394
devices may decrease after you install
Windows XP Service Pack 2," which is
indicated as a search result.
4
Read the information on the displayed
page, then download and install the update
program on the personal computer.
1.5 GHz or higher is
2) Installation of the IEEE1394b
driver
Install the IEEE1394b driver in accordance with
the following procedures.
<Note>
The IEEE1394b driver is installed for each unit
connected to a personal computer. If you use
more than one unit on a single personal
computer, install the drivers for the respective
units separately. If the IEEE1394b driver are not
installed, a sufficient transfer rate may not be
obtained.
1
In accordance with the descriptions in "4.
New Installation of the P2 Software" (from
pages 4 to 6 of the installation manual),
install the software up to Procedure No. 8.
2
When the window shown in Fig. 7 of
Procedure No. 8 (page 6 in the installation
manual) is displayed, select "AJ-PCD20 (P2
drive) 1394 driver" and then click OK.
3
When the message "Please connect AJ-
PCD20 (P2 drive) by 1394" is displayed,
connect this unit to the personal computer
using IEEE1394b. Confirm that all five drive
letters of this unit are displayed and then
press Install.
<Note>
When the unit is connected to a personal
computer through USB, remove the USB
cable and then connect using IEEE1394b.
4
The warning box may be displayed; in such a
case, click "Continue Anyway". The warning
box may be displayed two or more times.
5
In accordance with the instructions on the
screen, complete the installation and restart
the personal computer.
E-12