Installation & Connection - Grundig Venti series Instruction Manual

26. DISPLAY Button: Press the Display Button to show the information of the current playing disc.
27. SOURCE Button: Press the Source Button to show the Source List.
28. EXIT Button: Press the Exit Button to exit Menu settings.
29. CH+ / CH‐ Button: Press the Ch+ /CH‐ Button to scroll through the channel list.
30. REC / REP Button: Press the REC Button to record a TV program or press the REC Button in USB/DVD mode to select repeat
during playback.
31. RECALL/GOTO Button: Press the Recall/GOTO Button to return to the previous channel viewed in DTV mode. In DVD mode,
press the Recall/GOTO Button to choose the desired title, chapter or to search the desired title time and chapter time. For
super VCD and CD discs press this Button to search the desired disc time and track time and choose the desired track. Note:
During VCD playback, the PBC mode must be set to OFF.
Remote Control Battery Installation
The remote control requires two AAA batteries. Below are steps to assist you with replacing the batteries.
1. Open the back cover of the battery compartment.
2. Install the batteries into the battery tray. There is +/‐ polarity marking in the battery compartment. Please
ensure the polarity is correct.
3. Close the battery cover.
Caution:
1. Keep the batteries out of the reach of children.
2. Don't attempt to recharge, short‐circuit, disassemble, heat up or throw batteries into a fire.
3. Always replace both batteries at the same time and never mix new and old batteries.
4. Remove the batteries if unused for a long period of time to prevent possible corrosion.
Notes:
Do not drop, shake or step on the remote control.
Do not spill water on the remote control.
Aim the remote control directly at the remote sensor, for best use.
Replace the batteries, if the remote control does not operate from a close range.
Installation & Connection
1. Connect the TV RF antenna cable to the RF IN port on the back of the TV.
2. To connect your video sources (including DVD, VCR or Camcorder) you can connect them to the Video Input
via a RCA Cable (Red, White and Yellow cables).
3. For a better quality connection, the YPbPr Component Video Input can be connected with the YPbPr Video
Output of your DVD, VCR or Camcorder (cables not supplied).
4. For the best quality connection, the HDMI Input should be connected via the HDMI Output of your DVD, VCR
‐ 11 ‐