Table of Contents
Advertisement
REMOTE CONTROL BATTERY INSTALLATION
The remote control requires two AAA batteries. Below are steps to assist you with replacing the
batteries.
1.
Open the back cover of the battery compartment.
2.
Install the batteries into the battery tray. There is +/- polarity marking in the battery
compartment. Please ensure the polarity is correct.
3.
Close the battery cover.
CAUTION
1. Keep the batteries out of reach of children.
2. Don't attempt to recharge, short-circuit, disassemble, heat up or throw batteries into a fire.
3. Always replace both batteries at the same time. Never mix new and old batteries or batteries of a
different type.
4. If you don't intend to use the remote control for an extended period, remove the batteries to
prevent possible leakage and corrosion.
PLEASE NOTE
Do not drop, shake or step on the remote control.
Do not spill water on the remote control.
Aim the remote control directly at the remote sensor, for best use.
If the TV does not operate when operating the remote control from a close range, you need to
replace the batteries.
INSTALLATION AND CONNECTION
1. Connect the TV RF antenna cable to the RF IN port on the back of the TV.
2. Ensure you connect your Right and Left audio sources (including DVD, VCR, Camcorder and PC) to the
Left and Right Audio Input jacks 'L' and 'R'.
3. To connect your video sources (including DVD, VCR or Camcorder) you must connect them to the Video
All manuals and user guides at all-guides.com
- 10 -
Advertisement
Table of Contents
