Troubleshooting - Grundig Venti series Instruction Manual

Troubleshooting
If you have any issues or queries about the functions of this TV, please check the below table as we have
provided you with FAQs to assist with any issues or visit our FAQ page online – www.grundig.net.au. If this table
is not of assistance, please contact the Grundig Warranty line on 1800 509 394.
Issue
No power
No picture
No sound
Colour distortion
Remote control is
not responding
Screen glittering
under PC mode
Screen traversed
under PC mode
Solution
Turn off the unit at the remote and at the wall socket. Pull out the power
plug. Wait 60 seconds and then plug the power cord back in, turn the
power and unit back on.
Check that your cables and antenna have been connected firmly.
Check that your Picture Settings are correct.
Conduct a restore setting to return settings back to the factory default.
Check that your audio cables have been connected firmly.
Check that Muted Audio is not on and that Audio Settings are correct.
Conduct a restore setting to return settings back to the factory default.
Ensure that the equipment is connected properly.
Ensure that the AV video signal Input is connected properly.
Check the batteries and make sure there are no obstacles in the way of
the remote control and the sensor on the television.
Move closer to the remote sensor.
Using a digital camera (such as an iPhone camera) point the remote
control facing the camera from about 10 cm away. If you see a purple
flash each time you press the remote control then your remote control is
working.
Reset the computer and enter the safety mode, then select the
appropriate screen type by consulting the PC operation manual.
The phase is not appropriate. Enter the PC's settings and change to the
correct level.
‐ 31 ‐