Remote Control Battery Installation; Installation And Connection - Grundig VENTI II series Instruction Manual

Remote Control Battery Installation

The remote control requires two AAA batteries to operate. Below are steps to assist you with replacing the
batteries.
1. Open the back cover of the battery compartment.
2. Install the batteries into the battery tray. There are +/- polarity markings in the battery compartment.
Please ensure the polarity is correct.
3.
Close the battery cover.
Caution:
1. Keep the batteries out of the reach of children.
2. Don't attempt to recharge, short-circuit, disassemble, heat up or throw batteries into a fire.
3. Always replace both batteries at the same time and never mix new and old batteries.
4. Remove the batteries if unused for a long period of time to prevent possible corrosion.
Notes:

Do not drop, shake or step on the remote control.

Do not spill water on the remote control.

For best use aim the remote control directly at the remote sensor.

If the remote control does not operate from a close range replace the batteries.

Installation and Connection

1. Connect the TV RF antenna cable to the RF IN port on the back of the TV.
2. To connect your video sources (including DVD, VCR, PVR or Camcorder) you can connect them to the Video
Input via an RCA Cable (Red, White and Yellow cables).
3. For a better quality connection, the YPbPr Component Video Input can be connected with the YPbPr Video
Output of your DVD, VCR or Camcorder (cables not supplied).
4. For the best quality connection, the HDMI Input should be connected via the HDMI Output of your DVD, VCR
or Camcorder (cables not supplied). Please note that this connection is not available on most older devices.
5. AV Output allows you connect your TV with another monitor or TV sets when it is in DVD or TV mode.
6. VGA Input can be connected with the VGA Output of your PC to use this TV as a monitor. There is also a PC
Audio Input for your connection with PC, see image below.
7. Connect your TV to your Mains Power. Please only connect this TV to Mains Power that matches the power
- 13 -