Horizon Fitness T101 Owner's Manual page 7

ASSEMBLY STEp 3
HARdWARE fOR STEp 3 :
BOLT (B) SPRING WASHER (C)
20 mm
15 mm
Qty: 4 Qty: 4
RUNNING
DECK
CONSOLE CABLE
BASE FRAME
12
T101_CT53-OM_rev1_0.indd 12-13
Open hardware for step 3.
A
Attach lead wire to bottom end of
B
FLAT WASHER (D)
console cable. Pull lead wire through
15 mm
right console mast. After pulling the
Qty: 4
lead wire through the mast, the top of the
console cable should be located at the
top of the mast.
LEAD WIRE
With the running deck in the raised
C
position, attach the right console
mast to the base frame using 4 bolts
(b), 4 spring washers (c) and 4 flat
washers (d).
RIGHT CONSOLE MAST
NOTE: Be careful not to pinch any wires
while assembling the right console mast.
BOLTS (B)
SPRING WASHERS (C)
FLAT WASHERS (D)
ASSEMBLY STEp 4
HARdWARE fOR STEp 4 :
BOLT (E) SPRING WASHER (C) FLAT WASHER (D)
15 mm
15 mm 15 mm
Qty: 4 Qty: 4 Qty: 4
WATER BOTTLE POCKETS
CONSOLE CABLES
CONSOLE
FLAT WASHERS (D)
ASSEMBLE
SPRING WASHERS (C)
LEFT SIDE
FIRST
BOLTS (E)
CONSOLE MAST
A Disengage the deck lock latch with your foot to
lower the running deck.
B Open hardware for step 4.
C gently place the console on top of the console
masts. Attach the left side first using 2
bolts (e), 2 spring washers (c) and 2 flat
washers (d).
D Detach and discard the lead wire. Connect the
console cables and carefully tuck wires in
masts to avoid damage.
E Attach the right side of the console using 2
bolts (e), 2 spring washers (c) and 2 flat
washers (d).
NOTE: Be careful not to pinch any wires
while assembling the console.
F Insert water bottle pockets into console.
g Before the first use, lubricate the treadmill deck by
following the instructions in the MAINTENANCE
section in the TREADMILL gUIDE.
YOU ARE FINISHED!
2/16/11 8:26 AM
13