Table 2-4. Programming Needed After Upgrade To Release 1.1; Table 2-5. Programming Needed After Upgrade To Release 2.0 - AT&T MERLIN LEGEND Release 2.0 System Programming Manual

Programming with SPM
Table 2-5 lists features added with Release 2.0 of the communications
system. When you upgrade from Release 1.1 to Release 2.0, you must
program these features as the last step (Step 7) of the upgrade
procedure. When you upgrade from Release 1.0 to Release 2.0, you
must program the features listed in Table 2-4, then the features listed in
Table 2-5.

Table 2-4. Programming Needed after Upgrade to Release 1.1

System language
System Programming
Extension language
System Programming
SMDR language
System Programming
Printer language
System Programming

Table 2-5. Programming Needed after Upgrade to Release 2.0

Primary Rate Interface (PRI)
Sys
Program
Sys Program
Sys Program
Sys Program
Sys Program
Sys Program
Sys Program
Sys Program
Sys Program
Sys Program
Sys Program
DID Emulation on T1
Sys Program
Night Service Calling Group
Sys Program
Coverage VMS off
Sys program
2-40 Upgrade Procedure
More
Language
More
Language
More
Language
More
Language
LinesTrunks LS/GS/DS1
LinesTrunks LS/GS/DS1
LinesTrunks LS/GS/DS1
LinesTrunks PRI
LinesTrunks PRI
LinesTrunks PRI
LinesTrunks PRI
Lines Trunks PRI
LinesTrunks PRI
LinesTrunks PRI
Tables ARS
LinesTrunks LS/GS/DSl
NightSrvce GroupAssign
More Cntr-Prg
SystemLang
Extensions
SMDR
printer
Type PRI
FrameFormat
Suppression
PhoneNufier
B-ChannlGrp
NumbrToSend
Test TelNum
Protocol
DialPlanRtg
OutgoingTbl
Type More
Calling Group
Program Ext
Continued on next page
DID/All DID