AT&T MERLIN LEGEND Release 2.0 System Programming Manual page 80

Programming with SPM
CAUTION:
An unsuccessful or aborted Restore results in a frigid start:
All calls are dropped.
The system configuration is erased.
All system programming is lost, and the system returns to the
factory settings.
If the restore is being done remotely, the connection is dropped
immediately.
If this happens, reconnect to the control unit and do another Restore
immediately.
Restore is aborted under the following conditions:
if fewer boards are listed on the disk than on the control unit
if any real board is out of sequence with the boards listed on the disk
if phantom boards are not listed last
if the operating mode of the system being restored is Hybrid/PBX, but the
control unit processor module has been modified with a hardware strap
in place to operate only in Key mode
A successful Restore is followed by a cold start; however, you do not
automatically exit from SPM.
Step
2-30 Using SPM
Instructions
Display
If you are restoring from diskette, remove
the SPM diskette from Drive A and insert
the backup diskette.
Select Restore by pressing
two screens shown in Step 2 appear.
The first screen (Make a selection
for the) is an information screen. Entries
you make appear only on the second
screen.
If you are using a hard disk PC, go to
Step 3.
If you are using a floppy disk PC, highlight
GOTO FLOPPY (use the arrow keys) and
press
[ F7 ]
[ ].
. The