System Programming - AT&T MERLIN LEGEND Data Manual

System Programming

Planning Form
Entering Programming
Exiting Without Changes
What You See
System Programming:
Make a selection
System Extensions
SysRemunber Options
Operator
LinesTrunks AuxEquip
Exit NightSrvce>
4-4
Programming Instructions
Note: If you use equipment that rebroadcasts music or other copyrighted
materials, you may be required to obtain a copyright license from and pay
license fees to a third party such as the American Society of Composers,
Artists, and Producers (ASCAP) or Broadcast Music Incorporated (BMI).
Or, you can purchase a Magic on Hold® system, which does not require
you to obtain such a license, from AT&T or your authorized dealer.
Lines/trunks used for Maintenance Alarm
The factory setting for the analog data stations connected to an MLX
telephone using an MFM and for digital data stations should be changed to
one Intercom/System Access Ring button and one Intercom/System Access
Originate Only button plus lines/trunks and pools as required.
For MFMs, the idle line preference must be set to Intercom Voice (Key) or SA
Originate Only (PBX) (this is programmed using centralized programming).
An MFM endpoint (not the endpoint of the MLX telephone containing the
MFM) must have its automatic line selection set to SA (Intercom in Key
mode) to place a call (this is programmed using centralized programming).
The Copy procedure described in the next section can be used to copy
assignments from a data station previously programmed to an individual
data station or block of data stations with identical button assignment
requirements.
An alternate method for steps 5 and 6 (below) is to select Entry Mode (F6).
For each individual line/trunk to be programmed, identify the line/trunk (dial
or type the line/trunk number, logical ID, or slot and port number), and select
Enter (F10) or Next (F9) to assign the line/trunk to a button on the telephone
or Delete (F8) to remove the line/trunk from a button on the telephone.
Key or PBX System Forms 4b and 5b (reverse) MFM Adjunct
Button diagram
Console: Select Menu,
PC/SPM: Type SPM, press [any key], F1, F5
To exit from any screen without making changes, select Exit before saving
your entry or menu selection.
What You Do...
1. Select Extensions
Sys Program , Exit
Console
Extensions
PC
F6