Customer Support Information; Support Telephone Number - AT&T MERLIN LEGEND Data Manual

Customer Support Information

Support Telephone Number

AT&T provides atoll-free customer Helpline (1-800-628-2888) 24 hours a day (U.S.A. only). Call the Helpline, or your authorized
dealer, if you need assistance when installing, programming, or using your system.
Federal Communications Commission (FCC)
Electromagnetic Interference Information
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated
in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference, in which case the user will be required to correct the
interference at his own expense.
Canadian Department of Communications (DOC)
Interference Information
This digital apparatus does not exceed the Class A limits for radio noise emissions set out in the radio interference regulations of
the Canadian Department of Communications.
Le présent appareil numerique n'émet pas de bruits radioélectriques dépassant Ies Iimites applicable aux appareils
numéiques de la classe A prescribes dans Ie Réglement sur Ie brouillage radioélectrique édicté par Ie ministére des
Communications du Canada.
FCC Notification and Repair Information
This equipment is registered with the FCC in accordance with Part 68 of its rules. In compliance with those rules, you are
advised of the following:
Means of Connection. Connection of this equipment to the telephone network shall be through a standard network interface
jack: USOC RJ11 C, RJ14C, RJ21X. Connection to E&M tie trunks requires a USOC RJ2GX. Connection to off-premises
stations requires a USOC RJ11C or RJ14C. Connection to 1.544 Mbs digital facilities must be through a USOC RJ48C or
RJ48X. Connection to DID requires a RJ11 C, RJ14C or RJ21X. These USOCs must be ordered from your telephone
company.
This equipment may not be used with party lines or coin telephone lines.
Notifcation to the Telephone Companies. Before connecting this equipment, you or your equipment supplier must notify
your local telephone company's business office of the following:
The telephone number(s) you will be using with this equipment.
The appropriate registration number and ringer equivalence number (REN), which can be found on the back or bottom of
the control unit, is as follows:
If this equipment is to be used as a Key System, report the following number AS593M-72914-KF-E, and if the system
provides both manual and automatic selection of incoming/outgoing access to the network, report AS593M-72682-
MF-E. The ringer equivalence number for both systems is 1.5A.
For tie line connection, provide the telephone company the facility interface code (FIC) of TL31M and the service order
code (SOC) 9.0F.
Customer Support Information
vii