AT&T MERLIN LEGEND Data Manual page 99

System Programming
Data Hunt Group Member Assignments
Description
Considerations
Planning Form
Entering Programming
Exiting Without Changes
Assigns or removes a data station from a data hunt group. A data hunt group is
used to direct calls to groups of analog or digital data stations (not both).
Through data hunt groups a single extension number is assigned to the group
and is used by both inside and outside callers to reach the group.
A maximum of 32 data hunt groups with a maximum of 20 data stations per
group are allowed.
A data station can belong to only one group.
If you want to reassign a data station from one data hunt group to another,
you must remove the data station from the current data hunt group before
you assign it to the new group.
Extension Status feature must be set to Calling Group/CMS operation in
order for all groups to be available. See "Extension Status" instructions in
System Programming.
The recommended settings are
Circular Hunt (factory setting) assures equal distribution among modems.
No Delay Announcement (factory setting) used for voice communication
only.
Login status set to Auto Login (factory setting is Auto Logout) so you do
not have to login again after power failures or system restarts.
Programming menus and data entry screens labeled "Group Calling" are
used to program data hunt groups and voice station calling groups.
Data Form 3, Data Hunt Groups
Stations
Console: Select Menu,
PC/SPM: Type SPM, press [any key], F1, F5
To exit from any screen without making changes, select Exit before saving
your entry or menu selection.
Sys Program , Exit
Programming Instructions
4-31