Data Hunt Groups - AT&T Merlin II Feature Module 2 Data Communications Manual

Data Hunt Groups

PROCEDURE FOR
ADMINISTERING DATA
HUNT GROUPS
4-6 Hunt Groups
Data
Section "Planning Data Options," you may have grouped digital station
In 2,
jacks together into data hunt groups for more efficient data communications.
To administer a data hunt group, you assign the appropriate digital station
jacks to the group or remove them from the group.
. For a data hunt group for local host computer access, you administer the
station jacks for the Modular Processor Data Modules (MPDM) connected
to the computer.
. For a data hunt group for an outgoing modem pool, you administer the
station jacks for the Modular Trunk Data Modules (MTDM) connected to
the modems in the modem pool.
Get your Data Hunt Group Form and follow the appropriate procedure below
to set up or change data hunt group(s) for your system. If you're making a
change, be sure to record the new information on the form.
Your console beeps once (the MERLIN II system error tone) if
NOTE:
you try to assign a station jack to a data hunt group when:
The jack is on an analog station module.
• The jack has already been assigned to a different data hunt group.
The data hunt group already contains 16 jacks.
To administer data hunt groups, enter administration mode and follow the
appropriate procedure below.
With a MERLIN II System Display Console
1
From the administration menu, touch these buttons:
2
Dial the group number (default *870 through *875).
Touch
3
Green lights appear next to the buttons for any jacks that are assigned to
4
this data hunt group. Touch the Auto Intercom button for each jack
whose status you want to change until the green light shows the
apprpriate code:
Green light on = station jack assigned to data hunt group
Green light off = station jack not assigned to data hunt group
Touch ,then repeat steps 2 through 4 for each data hunt group
5
you want to administer.
Touch the appropriate button to administer another data option, or touch
6
Conference to return to the administration menu, or leave 'administration
mode.
With a 34-Button Console
Touch Message.
1
Dial #.
2
Dial the code (*870 through *875) for the data hunt group you want to
3
administer.