Special Information For Placing Data Calls - AT&T Merlin II Feature Module 2 Data Communications Manual

PRIVACY
SYSTEM SPEED DIAL
CALL PROGRESS
MESSAGES
5-14 Special information
for Placing
You can use the 3-digit code #31 to activate the Privacy feature when dialing
an outgoing data call. To instruct the modem to make the data call private,
the appropriate action:
take
– If the modem is connected to a Basic Telephone Module,
the line selection prefix.
– If the modem is connected to a BTMI, enter #31 afier the
prefix.
T place a data call to a number that has been assigned a System Speed Dial
O
code ( #60 through #99), take one of these actions:
– If the modem is connected to a Basic Telephone Module, enter the code in
place of the line selection prefix and telephone number. (If your system is
square, it places the call on the first available line in the sequence of lines
assigned to the station jack; if your system is pooled, it uses the main
pool for the call.)
– If the modem is connected to a BTMI, enter the code in place of the
telephone number.
If the Data Terminal Ready (DTR) lead is on, users may
messages when they place or receive data calls:
Appears after the notice of an incoming call if the caller
ABANDONED
disconnects before the data endpoint answers. This message
may be seen when the MPDM isn't set for automatic
answering.
Generated when the data endpoint being called answers.
ANSWERED
For an outside call, indicates that the line or line pool the
BUSY
caller selected or the data endpoint being called isn't available.
For an internal call, indicates that the destination data
endpoint is already on a call.
Appears if the caller enters an invalid dialing sequence.
DENIED
Generated when the caller goes offhook.
DIAL:
For an outside call, appears when ringing begins. For an
RINGING
internal call, appears when the data endpoint being called
begins alerting.
Appears if a resource needed for the call, such as a particular
TRY AGAIN
modem configuration, isn't available for use.
Generated during an internal call if the destination data
UNAVAILABLE
endpoint is not a working data endpoint or if the caller enters
the code for an empty data hunt group.
Data Calls
enter #31 before
line selection
see the following