Boards Support; Installation; Upgrade Path - Altigen Altiware HPBX 5.0A Administration Manual

Boards Support

The following types of board are supported in OE, ACM, and HPBX 5.0A:
• Quantum 4x8 Board Rev. D9 or above
• Quantum 8x4 Board Rev. D9 or above
• Quantum 0x12 Board Rev. D9 or above
• Quantum 4x8 DID Board Rev. D9 or above
• Triton T1/PRI Board (1.544 MHz) revision A3 or above.
• Triton T1/E1/PRI Board (2.048 MHz)
• Triton IP Boards revision A3 or above, which includes
— IP 4-Port Board
— IP 12-Port Board (G.711/G.723.1/G.729A+B)
— IP 30-Port Board (G.711 Only) (same hardware as 12-Port IP
Board)
• Triton Analog 12-Extension Board Rev A3 or above
• Triton Analog 12-Trunk LS/GS Board Rev A3 or above
• Triton Analog 12-Trunk LS Board Rev A3 or above
• Triton Resource Board Rev A3 or above

Installation

Important:
For a new installation, AltiWare OE/ACC 5.0A must be
installed AND the AltiServ HPBX Base License must be
registered prior to or during installing AltiWare HPBX.
1. To install AltiServ HPBX, launch Setup.exe from the AltiServ HPBX
folder.
2. The installation will check if the system has the HPBX Base License
installed and registered. If the HPBX Base License is not registered,
the application will stop installing.

Upgrade Path

The following migration/upgrade/migration paths are supported:
• OE/ACC 5.0A to HPBX 5.0A
HPBX 5.0A Supplement 3