ClearSounds A600 Operating Manual page 14

Desk / Table Mounting
1. Connect one end of the 6 ft phone cord to the line
jack on the back of the base and connect the other end
to a modular phone jack.
2. Plug the AC power adapter into the jack on the back
of the base, then plug the AC adapter into a standard
electrical outlet or surge protector.
NOTE: The adapter is required for the phone to work.
Wall Mounting
1. Install two self-tapping screws (not supplied) at a
distance of 60 mm apart from each other on a horizontal
line.
2. Insert the wall mounting bracket to the base as shown
in the figure on the right. The raised mounting pins line
up with the keyhole slots on the base. Once the holes
are lined up, snap the bracket securely into place.
3. Plug the AC power adapter into the jack on the back of
the base. NOTE: The adapter is required for the phone
to work.
4. Connect one end of the 8-inch phone cord to the line
jack on the back of the base and connect the other end
to a modular phone jack.
REAR OF BASE
14 – ENGLISH