ClearSounds A55 Quick Operating Manual

ClearsSounds® A55
Amplified Cordless Telephone
QUICK OPERATING GUIDE
This Quick Operating Guide will help you get
started with your new ClearSounds A55. For
additional installation options and complete
instructions which allow you to use all
features of this
Installation Guide and User Manual
Need help? Call (800) 965-9043
INSTALLATION
Setting Up the Base Unit
1. Install the telephone line cord.
2. Install the AC adapter. USE ONLY with
the ClearSounds AC Adapter provided.
3. Place the handset in the base after
following the Battery Installation
directions.
Battery Installation
Before using the telephone, charge the
batteries for 24 hours.
1. Slide the battery compartment open.
2. Insert three new AAA Ni-MH
Show Desktop.scf
(provided) following the polarity
marking in the battery compartment.
3. Replace the battery cover.
4. Place the handset on the base. The
unit beeps once and the battery charge
indicator lights up.
IMPORTANT! Only use AAA NiMH
rechargeable batteries. DO NOT USE
REGUALR ALKALINE OR CARBON
BATTERIES.
RINGER VOLUME & STYLE
Adjust the Ringer
1. Begin by selecting the setting for the
ringer: OFF, LO, MED, HI (the middle
4-position switch located on the bottom
of the base).
ClearSounds® Telephone: 800-965-9043 / TTY: 800-814-5359 / Spanish: 888-758-6056
e-mail: customerservice@clearsounds.com website: www.clearsounds.com
phone, refer to
rechargeable batteries
2. Your cordless handset is preset with
the ringer turned ON. If you prefer to
turn OFF the handset ringer, see page
8 in the manual.
NOTE: If both the handset and base ringers
are set to OFF, the visual ringer will flash to
indicate there is an incoming call.
your
Using the Vibration Setting on the Handset
and Base. The vibration call alert feature
notifies you of incoming calls by making the
handset and/or optional shaker vibrate.
1. To turn ON the handset vibrate mode,
select the TOP position on the
SHAKING switch located below the
"AMPLIFY" button (see page 4-5 in
manual).
2. To use the optional Shaker for the
base, connect the Shaker into the
socket located on the side of the base.
(see page 4-5 in manual).
3. Place the Shaker where you can feel it
under a mattress or seat cushion of a
chair.
NOTE: The shaker is an optional device
(sold separately).
PROGRAMMING PHONE BOOK
For frequently dialed numbers:
1. Begin by entering a phone number as
you would dial it.
2. Press the "MEMO" button once and
then the LCD will show NAME.
3. Enter the name using the
corresponding letters on the keypad.
i.e.: Press the 2 key once for A, twice
for B and 3 times for C. Use the 1 key
to insert a space between the name.
4. Press the "MEMO" button to confirm
and a confirmation beep will sound.

TELEPHONE OPERATION

Make A Call
1. Press the "TALK" button.
2. Dial the number or select one of the
phonebook entries.