Installation Guide
System installation at a glance
The equipment interface module (EIM) allows you to control a baseboard heater, a
convector or a fan-forced heater in a 120-volt, 208-volt or 240-volt application from a
EConnect™ wireless thermostat.
EIM in remote
junction box
Electrical
panel
Installation procedure
Install the equipment interface module (EIM)............................................... Pages 3 - 6
Install batteries in wireless devices ..................................................................... Page 7
Link all devices to wireless network ........................................................... Pages 7 - 10
Exit wireless setup .............................................................................................Page 11
Customize thermostat (installer setup)......................................................Pages 11 - 18
Mount thermostat and outdoor sensor ..................................................... Pages 19 - 20
For error codes, see page 20.
To verify the signal strength, see page 21.
To replace a wireless device, see pages 21-22.
For specifications and replacement parts, see page 23.
Heater
Supply wires
SAVE THESE INSTRUCTIONS
Thermostat
Thermostat
Wireless connection
2
EIM in heater
Remote
control
1.
Outdoor
air sensor