Link Outdoor Sensor To Wireless Network (Optional); Link Remote Control To Wireless Network (Optional) - Aube Technologies EConnect Wireless Thermostat Kit TA7210 System Installation Manual

Installation Guide

Link outdoor sensor to wireless network (optional)

1) Make sure the Connect light on the EIM is
flashing (see page 7).
If you have more than one wireless thermostat,
make sure to activate the wireless setup from
an EIM linked to the thermostat. For example,
to display
thermostat Y, you must activate the wireless
setup from either EIM B or C, not A.
2) Press the Connect button on the back of the
sensor.
3) After 15 seconds, check if the thermostat is displaying a value for the outdoor
temperature reading.
If you have more than one wireless thermostat, repeat steps 1 and 3 for each thermostat.

Link remote control to wireless network (optional)

1) Make sure the Connect light on the EIM is flashing (see page 7).
If you have more than one wireless thermostat, make sure to activate the wireless setup
from an EIM linked to the thermostat. For example, to link the remote control to thermostat
Y, you must activate the wireless setup from either EIM B or C, not A.
2) Press CONNECT at the remote
control.
3) When the remote control displays
Connected (after a short delay),
press DONE.
4) Press NO at the next screen to save
and exit. (Or press YES and repeat
steps 1-4 to link to another network).
the outdoor temperature
Bathroom
wireless network
Thermostat X
EIM A
Press and
release
on
Bedroom
wireless network
Outdoor
sensor
Thermostat Y
Remote
control
EIM B
CONNECT
WIRELESS SETUP
10
EIM C
YES
CONNECT MORE?
Press to link to
Press to
another network
save and exit
NO