Adjusting The Indexer Lever Assembly - Kodak Carousel 4200 Service Manual

SERVICE MANUAL
Adjustment Specification
This adjustment adjusts the strobe and timing of the INDEXER LEVER. The gate edge of the black plastic of the
INDEXER LEVER should be between the 2 holes at position 2.

Adjusting the INDEXER LEVER ASSEMBLY

Warning
Dangerous Voltage
[1] Disconnect the main power.
[2] Do the removal for the MECHANISM ASSEMBLY.
[3] Place the MECHANISM ASSEMBLY on the MECHANISM RUNNING FIXTURE.
[4] Check the alignment of the INDEXER LEVER with the hole in the TOP PLATE ASSEMBLY at Position 1.
[5] Bend the INDEXER LEVER to the correct position.
[6] Check the travel of the INDEXER LEVER in the FORWARD position. When the INDEXER LEVER moves in
the FORWARD position, the gate edge of the black plastic should be between the 2 holes at Position 2.
[7] Bend the INDEXER LEVER until you reach the correct position.
MECHANISM
RUNNING FIXTURE
Adjustment Specification
Use a MECHANISM RUNNING FIXTURE. Use TL-3001 to measure the height of the SLIDE LIFT LEVER. The
LEVER should make contact with the low surface of TL-3001. The LEVER should not make contact with the high
surface of TL-3001.
26
MECHANISM
ASSEMBLY
TOP PLATE
Bend
here.
position 1 position 2
18NOV97 – SM5440-1
A091_0008HCA
A091_0008HA