Replacing The Mechanism Assembly; Installing The Mechanism Assembly - Kodak Carousel 4200 Service Manual

Replacing the MECHANISM ASSEMBLY

SCREW (3)
LENS
MOUNT
SCREW
FOCUS KNOB
A091_4047CCA
A091_4047CA

Installing the MECHANISM ASSEMBLY

Important
To insert the SELECT BUTTON into the hole in the SELECT LEVER when installing the MECHANISM ASSEMBLY,
hold the SELECT BUTTON completely down.
[1] Do the removal procedure for the MECHANISM ASSEMBLY in reverse order.
SM5440-1 – 18NOV97
Dangerous Voltage
[1] Disconnect the main power.
[2] Do the replacement procedure for the LOWER
[3] Cut and remove the necessary WIRE TIES.
[4] Disconnect the 2 wires from the CYCLE
MECHANISM
[5] Pull the SMALL CIRCUIT BOARD up.
ASSEMBLY
[6] Disconnect all wires connected to the
[7] Remove the FOCUS KNOB from the FRONT
[8] Remove the 3 Torx SCREWS from the LENS
[9] Lift and move the LENS MOUNT ASSEMBLY up.
[10] Do the replacement procedure for the MOTOR.
[11] Remove the 3 Torx SCREWS from the
[12] Loosen the SCREW on the STABILIZER WALL
There might be a bind between the SELECT LEVER
and the SELECT BUTTON when removing the
MECHANISM ASSEMBLY. Do not use force; this
might cause damage to the SELECT BUTTON.
[13] Remove the MECHANISM ASSEMBLY.
Replacements and Installations
Warning
HOUSING ASSEMBLY.
SOLENOID on the SMALL CIRCUIT BOARD.
MECHANISM ASSEMBLY:
• 1 yellow wire from CYCLE SWITCH
• 1 orange wire from WIRE NUT
• 1 green wire from POWER CORD
• 2 green ground wires from the lower
MECHANISM ASSEMBLY
PANEL.
MOUNT ASSEMBLY.
MECHANISM ASSEMBLY.
approximately half way.
Caution
13