Replacing The Auto-Focus Bracket Assembly; Installing The Auto-Focus Bracket Assembly; Replacing The Cam Stack Assembly And Cycle Lever Assembly - Kodak Carousel 4200 Service Manual

Carousel projectorsl
Hide thumbs Also See for Carousel 4200:
Table of Contents

Advertisement

SERVICE MANUAL

Replacing the AUTO-FOCUS BRACKET ASSEMBLY

Warning
Dangerous Voltage
[1] Disconnect the main power.
[2] Do the replacement procedure for the LOWER HOUSING ASSEMBLY.
[3] Cut and remove the necessary WIRE TIES.
[4] Disconnect the 2 wires from the CYCLE SOLENOID on the SMALL CIRCUIT BOARD.
[5] Pull the SMALL CIRCUIT BOARD up.
[6] Do the replacement procedure for the MECHANISM ASSEMBLY.
[7] Remove the Torx SCREW from the WORM PULLEY.
[8] Remove the WORM PULLEY.
[9] Remove the 2 Hex SCREWS from the CYCLE SOLENOID.
[10] Remove the CYCLE SOLENOID.
[11] Remove the Phillips SCREW from the AUTO-FOCUS BRACKET ASSEMBLY.
[12] Pull and remove the AUTO-FOCUS BRACKET ASSEMBLY through the hole where the CYCLE SOLENOID
was.
SCREW
AUTO
FOCUS
CYCLE
BRACKET
SOLENOID
ASSEMBLY

Installing the AUTO-FOCUS BRACKET ASSEMBLY

[1] Do the replacement procedure for the AUTO-FOCUS BRACKET ASSEMBLY in reverse order.

Replacing the CAM STACK ASSEMBLY and CYCLE LEVER ASSEMBLY

Warning
Dangerous Voltage
[1] Disconnect the main power.
[2] Do the replacement procedure for the MECHANISM ASSEMBLY.
[3] Remove the INDEXER LEVER ASSEMBLY from the TOP PLATE of the MECHANISM ASSEMBLY.
[4] Remove the Torx SCREW from the WORM PULLEY ASSEMBLY.
[5] Remove the WORM PULLEY ASSEMBLY.
[6] Remove the DIRECTION LEVER LINK from the DIRECTION LEVER.
14
SCREW (2)
SCREW
WORM
PULLEY
A091_4023BCA
A091_4023BA
18NOV97 – SM5440-1

Advertisement

Table of Contents
loading

Table of Contents