Further Parameters And Options - Kyocera ECOSYS FS-1320D User Manual

3.2.6 Further parameters and options

Note
The following description of parameters and options applies to one-
dimensional barcodes. Different or additional rules apply to some barcodes,
primarily two-dimensional ones. These are described in the chapter entitled,
"B
ARCODES AND
are Datamatrix, QR Code and Australia 4-state.
As described in the preceding section, the sequence <Esc>(s#T is used. However,
this is only the simplified basic form: you have the option of influencing the printout of
the barcode by entering further parameters. These are detailed below. All of these
parameters are optional, i.e. you can omit these if your application does not require
plain text, for example, or if the width and length in default form are already sufficient
for the requirements of your application.
Example:
<Esc>(s1p301h20v4b4s24670T instead of just <Esc>(s24670T
v parameter
Height of the barcode in dots (1/72 in.)
Values of 0.2 to 999 are permitted.
b parameter
Width of the bars
These values are separated by commas. In the case of a barcode with two bar
widths, e.g. Code 39, enter two values, e.g. <Esc>(s6,12b...; or in the case of a
code with four
<Esc>(s6,12,18,24b...
Values from 2 are permitted. Maximum values: 100 for the narrowest bar, 200 for the
second-narrowest, 300 for the second-widest and 400 for the widest.
s parameter
Width of the spaces
These values are separated by commas. In the case of a barcode with two space
widths, e.g. Code 39, enter two values, e.g. <Esc>(s6,12s...; or in the case of a
code with four space
<Esc>(s6,12,18,24s... Values from 2 are permitted. Maximum values: 100 for
the narrowest space, 200 for the second-narrowest, 300 for the second-widest and
400 for the widest.
M
ATRIX CODES WITH DIFFERENT PARAMETERS
bar widths, e.g.
widths, e.g.
Code 128, enter
Code 128, enter
28
". These barcodes
four values, e.g.
four values, e.g.