Installation And Commissioning; Hardware Installation - Kyocera ECOSYS FS-1320D User Manual

2 Installation and commissioning

2.1 Hardware installation

The software is supplied on a Compact Flash card ('CF card'). To use this card, it has
to be kept permanently in the printer. All you have to do to install the card is to insert
it into the slot in the printer.
Note that, for technical reasons, starting with Version 3.00 the Barcode Flash solution
is available as Type A and Type B. The following multifunctional printers (MFP)
require Type B:
KM-3050, KM-4050, KM-5050, KM-3040, KM-3060
All other printers and MFP require Type A.
Where differences exist between the installation of Type A and Type B, these are
described below. Please ensure that the proper installation is available on the
compact flash card. You can use the directory to determine whether this is the case
and reprogram the card if necessary. You can do so by copying the right file to the
printer. Please observe the instructions in this regard at the beginning of the update
file.
Please nothe that only the PCL Barcode Flash cards can be re-programmed by the
end user. The KYOmulticode card (PCL Barcode Flash with Unicode font extension
and additional fonts) has to be re-programmed by Kyocera Mita customer service if a
change between Type A and B or vice versa is necessary.
N ote
Please note carefully the general tips on working with CF cards in your printer
manual. This manual will also contain a description of where the CF slot is on
your particular device.
Data and programs for Kyocera Mita printers always have to be present in a
particular form on Compact Flash cards. In the case of the barcode solution, these
are a number of what are known as 'partitions' in which additional fonts and macros
for the status page and function calls are stored for the user in addition to the
software.
The following partitions are available once the CF card has been inserted:
Type A:
Barcode Status
Barcode Init
Barcode Remove
KM BC 3.00.1
BSTP
STP1
STP2
KM_Logo
17