Auto Triggering (34410A/11A); Single Triggering (34410A/11A) - Agilent Technologies L34410A User Manual

2 Features and Functions

Auto Triggering (34410A/11A)

This mode is available from the front panel only.
The power–on trigger default mode for the multimeter is front panel
operation, in auto trigger mode.
• Auto triggering takes continuous readings at the fastest rate possible for the
• Auto triggering is a front panel mode similar to immediate triggering from
• To enable auto triggering, press

Single Triggering (34410A/11A)

This mode is available from the front panel only.
• The multimeter takes one reading, or a number of readings specified by a
• The Trig annunciator indicates that the multimeter is waiting for a trigger.
68
specified measurement configuration (function, range, resolution, and so
forth).
the remote interface, but also sets the sample count to infinite and
automatically initiates continuous measurements.
TRIGGER > AUTO
sample count you enter, each time you press
external trigger signal on the rear-panel Ext Trig connector (see
Triggering" on page 75). See also
page 71.
, or upon receiving an
"Number of Samples per Trigger"
34410A/11A/L4411A User's Guide
"External
on