NETGEAR MVBR1210C User Manual page 18

Mobile Voice HSPA+ Broadband 11n Wireless Router MVBR1210C
Table 3. Settings
Fields and check boxes
Internet Service Provider
Access Number
PIN code
APN
PDP type
Connect automatically at startup
Roaming automatically
Use internal antenna
Wireless Button Configuration
Connection status
Description
Select your Internet service provider from the drop-down list.
The remote site's phone number.
Pin code of the SIM card, where applicable.
Access point name.
Select the type of packet data protocol:
• IP
• PDP-IP
• PPP
• PPP-IP
When this check box is selected, the modem automatically connects
to the network when powered up. This should be selected after login
information is provided.
When this check box is selected, the unit might roam to any available
operator in range and might incur roaming charges.
If this check box is selected, the router will use the internal antenna
rather than the external antenna.
Select the option to determine what happens when the WPS button
on the front panel is pressed.
• Control Wi-Fi Only. Pressing the button toggles the WiFi function.
If WiFi is turned on, pressing the button turns off the WiFi. Pressing
it again turns on the WiFi. This function is available only if the WiFi
function is enabled. The wireless broadband function is unaffected.
• Control Both Wi-Fi and Wireless Broadband. Pressing the push
button toggles both the WiFi function and wireless broadband at
the same time. If WiFi is turned on, pressing the button turns off the
WiFi. At the same time, the wireless broadband connection is
disconnected. If you press the button again, WiFi is turned on and
the router attempts to reestablish the wireless broadband
connection. Depending on the coverage, wireless broadband
coverage might or might not be connected successfully.
Current WAN port status.
Connecting to the Internet
18