Configuration File Settings; Ip Addresses & Port Numbers - Neoware e140 - Thin Client User Manual

Configuration File Settings

IP Addresses & Port
Numbers
The following configuration file setting descriptions generally fol-
low the order shown in the example
shown in the previous section.
Comments can be specified in the configuration file by beginning
the line with the # character.
Caution: Neoware Image Manager will erase existing comments
when it modifies a configuration file.
An example of a configuration file that supports multiple volumes
can be found at the end of this chapter.
address
(optional – default:
0.0.0.0
Specifies the IP address used by the
HDD related) communications. Set this parameter if your server has
several NICs or IP addresses.
port
(optional – default:
2184
Specifies the port number used by the
admin_addr
(optional – default: same as
Specifies the IP address that
purposes (NVDDAdmin protocol). Useful if the server contains
multiple network cards.
admin_port
(optional – default:
29035
Specifies the port number used by the administration interface.
The NVDD Configuration File
nvdd.smalldisk.vol.conf
)
server for NVD (virtual
nvdd
)
server.
nvdd
)
address
must use for administration
nvdd
)
Configuration File Settings
file
217