Initial Setup; Network Configuration - American Megatrends StorTrends User’s guide User Manual

Initial Setup

Network Configuration

Once the StorTrends® iTX is installed in a new system, please ensure that the initial network configuration is
proper. The system factory defaults to DHCP setup. The configured network settings can be verified by the
following CLI commands:
CLI> get –-type or –t port
-–name or –n NIC-1
--info or -i
network <Enter>
Example: get –t port –n nic-1 –i network
This will display the NIC-1 network settings.
To configure static IP to this port:
CLI> set –-type or –t port
–-name or –n NIC-1
–-ip or –i 10.0.0.100
–-mask or –m 255.255.255.0
–-gate or –g 10.0.0.7 (optional)
--pridns or –p 10.0.0.2 (optional)
--secdns or –s 0.0.0.0 (optional)
--dnssuff or –f ami.com (optional)
network <Enter>
Example: set –t port –n nic-1 –i 10.0.0.100 –g 10.0.0.7
-p 10.0.0.2 –s 0.0.0.0 –f ami.com network
Here 10.0.0.100 is the static IP address, 255.255.255.0 is netmask and 10.0.0.7 is the network gateway.
StorTrends® iTX Software CLI (Command Line Interface) (Version 2.7) User's Guide
2