Network Controller Configuration - American Megatrends StorTrends User’s guide User Manual

Network Controller Configuration

These commands configure the network ports. They can also be used to create virtual bonding network ports
(teams) for high availability and/or load balancing.
Command Argument
get network -t/--type {port}
-c/--count
-x/--xml
For example: get –t port –c count network
get network -t/--type {port / alias}
-n/ --name <name of the adapter >
-i/--info
-x/--xml
set network -t/--type {port}
-n/--name <Name of the NIC>
-d/--dhcp
-x/--xml
For example: set –t port –n nic-1 –d network
set network -t/--type {port / alias}
-n/--name <Name of the NIC>
-i/--ip <IP Address>
-m/--mask <net mask>
-g/--gate <Gateway> (optional)
-p/--pridns <Primary DNS> (optional)
-s/--secdns <Secondary DNS>(optional)
-f/--dnssuff <DNS suffix>(optional)
-j/--mtu <size> (optional)
get network -t/--type {adp}
-c/--count
-x/--xml
list network -t/--type {adp}
create network -t/--type {team}
-m/--mode {1/2/3}
-p/--pri <primary NIC>
-s/--sec <secondary NIC>
-x/--xml
Creates a team named Team-1, Team-2, and so on,
depending on available NICs in system
For example: create –t team –p nic-1 –s nic-2 –m 1
network
delete network -t/--type {team}
-n/--name <name of the Team>
-x/--xml
For example: delete –t team –n Team-1 network
get network -t/--type {team}
-i/--info
-n/--name <name of the Team>
-x/--xml
For example: get –t team –i –n Team-1 network
get network -t/--type {team}
-i/--info
-n/--name <name of the Team>
-x/--xml
list network -t/--type {adp/port}
-x/--xml
add network -t/--type alias
-n/--name <alias name>
Description
Gets the number of ports.
Displays the given network port
information.
Configures the given network port
to work with DHCP.
Configures the specified network
port to work with the given
STATIC IP configuration.
Displays the number of network
adapters present.
Displays the available network
adapters and their status.
Creates a network team with the
given mode. The supported modes
are:
1 – Balance Round Robin
2 – 802.3 AD (with pre-configured
switch)
3 – Balance TB
Deletes the network team with the
given name.
Displays the number of NICs
present in the given team.
Displays the given network team
information.
Displays various information for
the available network ports
including their status.
Adding an alias adapter for a
specific NIC port
Chapter Two: Command Set 17